Environment for installing horizontal machining center
The horizontal machining center should be installed in a place far away from the seismic source, not exposed to direct sunlight, no heat radiation, and no humidity. If there is an earthquake source near the place where the horizontal machining center is installed, an anti-vibration trench should be set around the horizontal machining center. If the anti-vibration groove is not provided, it will directly affect the machining accuracy and stability of the horizontal machining center, and over time will affect the poor contact of the electronic components, failures, and affect the reliability of the horizontal machining center.
Strict control of voltage and current
Horizontal machining centers are generally installed in processing workshops, and there are many mechanical equipment in the processing workshops, which will inevitably lead to large fluctuations in the power grid. Therefore, the installation position of the horizontal machining center must strictly control the voltage and current of the power supply. The voltage and current of the power supply must be controlled within the allowable range of the horizontal machining center. The voltage and current of the power supply must be kept stable, otherwise it will directly affect the horizontal machining center. The normal operation of the machining center.
Temperature and humidity will directly affect the horizontal machining center
Horizontal machining centers generally need to be in an environment below 30 degrees Celsius to work normally. Under normal circumstances, exhaust fans and air coolers are installed in the distribution box of horizontal machining centers to ensure that the electronic parts and central processing work at a constant temperature. . If the temperature and humidity are too high, the life of the components of the control system will be reduced, leading to an increase in the failure of the horizontal machining center for no reason. If the humidity increases, dust will increase on the integrated circuit board and directly cause poor contact and short-circuit failures.
Machine tool factory parameter setting
When using a horizontal machining center, customers cannot change the factory parameter settings of the machine at will, because these factory parameter settings are directly related to the dynamic characteristics of each component of the horizontal machining center. Only the gap compensation parameter value can be set according to the actual situation. If you want to change the factory setting parameters, you should contact the manufacturer, and change the factory parameter settings under the guidance of the manufacturer’s technicians.
Please keep the source and address of this article for reprinting：Pay attention to four main points when using a horizontal machining center
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.：Cnc Machine Wiki，Thanks